No products in the cart.
2-Channel High-Power Relay Controller Shield + 6 GPIO with IoT Interface
Features
- 2-Channel High-Power Relay Controller with IoT Interface
- 6-Channel Programmable Digital Input/Output (GPIO)
- Compatible with Electron, Photon, Bluz, or RedBear
- Adaptable to Onion, PyCom, Raspberry Pi, Arduino
- MCP23008 I2C Controlled Mechanical SPDT Relays
- Available with 20-Amp SPDT or 30-Amp SPST Relays
- World’s Most Expandable Controller with I2C Expansion Port
- Wireless Remote Operation with Key Fob Expansion Option
- ESP8266 and USB IoT Interface Modules are Also Available
- IFTTT Firmware Available for Internet Relay Control
- Example Libraries Available on GitHub
$ 46.95
In Stock
Add to Wishlist
CompareAdd to Wishlist
Description
This IoT 2-channel high-power relay controller is capable of hosting many types of IoT communication modules, including Particle Photon, Electron, Arduino, and more. On-board relays are ideally suited for control of high power loads up to an absolute maximum of 30 Amps at 240VAC, depending on the relay chosen during purchase. This design is suitable for some mildly inductive loads when used with external induction suppression capacitors, but focuses primarily on resistive load switching. This controller includes 20-Amp SPDT or 30-Amp SPST relays, customized when added to your shopping cart.
This controller is based on the MCP23008, a common I2C interface chip for GPIO applications. In this design, the GPIO port is used to control 2 onboard SPDT relays. Six programmable Digital Input/Output port pins are also available via screw terminals for use in Contact Closure detection applications or monitor and control external TTL circuits. Three on-board address jumpers allow up to 8 similar devices (based on the MCP23008 or MCP23017) to be chained to the same I2C bus for individual control. On-board status LEDs display the on/off status of each relay. This controller may be powered using our optional power supply or with 12VDC and direct screw terminal connection of bare power wires.
IFTTT
Leverage the power of IFTTT.com and Particle services to do almost anything. Send a tweet if someone rings your doorbell, send a notification to your phone if someone opens a door, turn on almost anything right from your phone with a simple setup, the possibilities are endless. NCD provides this controller with an optional pre-programmed Particle Photon module for easy connection to IFTTT. No programming required! Just use the simple IFTTT interface to set up your different configurations.
Powered By Particle
Give your Particle Photon the power to interact with the real world in ways never before possible. Use the optional Particle Photon module pre-flashed with our custom IFTTT firmware, NCD compatible shields allow for control of many types of relays, monitoring digital and analog sensors, and much much more. Chain I²C accessory boards to your system to add whatever you may need for your next control and automation project.